search_all
Home Soundproof Garage - Garage Conversion Stage 2 Soundproof a Room Stage2 Part 3
Soundproof a Room Stage2 Part 3

I was fortunate enough to already have a 32 amp fuse board in my garage. Since electrical power will be needed within the practice room, I had to run all the necessary wiring from the fuse board to the required locations in the room.

 

For 240/220v supplies (e.g. UK and Europe)

The following circuits were used:

  • 5 amps for low voltage lighting.
  • 8 amps for a 2KW electrical heater
  • 16 amps for 3 double plug sockets
  • 5 amps for an extractor fan
For 110v supplies (e.g. US and Canada)...
For North American readers your supply runs at 110V, so you will have to double the current load on each circuit in order to be able to draw the same power. So to supply the same power for each circuit quoted above, you would need to supply the following current load:

 

  • 11 amps for low voltage lighting
  • 18 amps for a 2KW electrical heater
  • 35 amps for 3 double plug sockets
  • 11 amps for an extractor fan




Articles by this Author:

Soundproof a Room Stage 2 Part 4Soundproof a Room Stage 2 Part 4
The type of insulation used was slabs of 75mm Rockwool RWA45 (45 kgm-3). These were fixed to the wall by using short lengths of metal strapping to act as washers. These were placed onto 100mm screws...
Read More >>
Soundproof a Room Stage3 Part 2Soundproof a Room Stage3 Part 2
The inline fan is a Vent Axia ACH-100 that has been mounted on a sheet of foam insulation sandwiched between two sheets of chipboard to provide some insulation. The idea here was to prevent the vibration...
Read More >>
Soundproof a Room Stage 5 Part 1Soundproof a Room Stage 5 Part 1
Install Low Voltage Lighting The low voltage lights were installed immediately after the inner walls were boarded out. The transformer for the lights is located in the ceiling void above the practice...
Read More >>
Soundproof a Room Stage 3 Part 1Soundproof a Room Stage 3 Part 1
Because the room needs to be sound-proof, in the simplest sense, this means that the room must also be air-tight. Obviously, an air-tight room is not practical, so ventilation has to be achieved without...
Read More >>
logo footer   Designed by Marshallarts (c)1999-2010 - All Rights Reserved
php script encode decode php script encode decode