search_all
Home Soundproof Garage - Garage Conversion Stage 3 Soundproof a Room Stage3 Part 2
Soundproof a Room Stage3 Part 2

Soundproof Garage

The inline fan is a Vent Axia ACH-100 that has been mounted on a sheet of foam insulation sandwiched between two sheets of chipboard to provide some insulation. The idea here was to prevent the vibration from the fan being transmitted back down into the room.

Fan standing on the chipboard and foam platform

 

Soundproof Garage

Second section of duct from fan position to room inlet.

Soundproof Garage


Related Articles:


Articles by this Author:

Soundproof a Room Stage 1 Part 1Soundproof a Room Stage 1 Part 1
The problems When building a music practice room, the most important problem to be solved is stopping sound from escaping. If your practice space leaks sound like water through a sieve, then this...
Read More >>
Soundproof a Room Stage 2 Part 2Soundproof a Room Stage 2 Part 2
Lay a Damp Proof Membrane DPM Due to the fact that the damp-proof course around my garage has been known to leak during heavy rain, I wasn't going to take any risks with flooding in future. So even...
Read More >>
Soundproof a Room Stage2 Part 3
I was fortunate enough to already have a 32 amp fuse board in my garage. Since electrical power will be needed within the practice room, I had to run all the necessary wiring from the fuse board to the...
Read More >>
Soundproof a Room Stage3 Part 3Soundproof a Room Stage3 Part 3
Isolate fan mounting   Unfortunately, I discovered (after the ceiling of the practice room had been put up), that the foam used to provide vibration insulation was too dense. A significant level of...
Read More >>
logo footer   Designed by Marshallarts (c)1999-2010 - All Rights Reserved