search_all
Home Soundproof Garage - Garage Conversion Stage 5 Soundproof a Room Stage 5 Part 1
Soundproof a Room Stage 5 Part 1

Install Low Voltage Lighting

low voltage studio lighting

The low voltage lights were installed immediately after the inner walls were boarded out. The transformer for the lights is located in the ceiling void above the practice room.Low voltage lighting installed

The hooks to support the low voltage light cables are screwed into plasterboard fixings. Later, when the internal insulation and fabric finish is aplied, we will have to cut holes to allow the cables through the fabric.





Articles by this Author:

Soundproof a Room Stage 4 Part 3Soundproof a Room Stage 4 Part 3
The inner walls of the practice room were then boarded out with a double layer of plasterboard. Boarding out the inner walls A standard door (in the UK at least) is 30" wide. However, I thought...
Read More >>
Soundproof a Room Stage 1 Part 5
Absorbency The acoustic absorbency of a material determines the proportion of energy removed from a sound wave when it reflects off that material. Absorbency values are almost always quoted as a...
Read More >>
Soundproof a Room Stage2 Part 5Soundproof a Room Stage2 Part 5
In order to gain more height in the practice room, we had to lift the existing joists. In addition to this, the spacing of the existing ceiling joists was not convenient for the new ceiling design, so...
Read More >>
Soundproof a Room Stage 5 Part 5Soundproof a Room Stage 5 Part 5
The inner and outer doors could only be hung after the fabric had been applied to the inner walls of the practice room. The reason for this is that fabric needed to be tensioned onto the door frame...
Read More >>
logo footer   Designed by Marshallarts (c)1999-2010 - All Rights Reserved