search_all
Home Soundproof Garage - Garage Conversion Stage 5 Soundproof a Room Stage 5 Part 5
Soundproof a Room Stage 5 Part 5

The inner and outer doors could only be hung after the fabric had been applied to the inner walls of the practice room. The reason for this is that fabric needed to be tensioned onto the door frame itself, and then the door lining could be added to give a neat finish

.sooundproof room skirting carpetThe inner and outer doors are separated by a 500mm (20") gap. The holes are for ventilation

The inner and outer doors could only be hung after the fabric had been applied to the inner walls of the practice room. The reason for this is that fabric needed to be tensioned onto the door frame itself, and then the door lining could be added to give a neat finish.

Skirting and carpeting

The skirting board is moulded MDF that I painted with a course brush to give it a wood-grained effect.

For the carpet, I got some tough wearing, 50cm x 50cm polypropylene carpet tiles. Unfortunately, the DIY store did not have enough of the beige colour I wanted, so I had to buy the remaining tiles in a different colour. What I ended up with was a blue border about 10cm (4") wide around the outside, main floor area in beige

here<
sooundproof room skirting carpet A tasteful (?) blue carpet border





Articles by this Author:

Soundproof a Room Stage 1 Part 1Soundproof a Room Stage 1 Part 1
The problems When building a music practice room, the most important problem to be solved is stopping sound from escaping. If your practice space leaks sound like water through a sieve, then this...
Read More >>
Soundproof a Room Stage4 Part1Soundproof a Room Stage4 Part1
The floor and walls of the inner room can easily be isolated from the concrete garage floor by putting down a 25mm (1") layer of polystyrene sheet. Despite being polystyrene, this material is very strong...
Read More >>
Soundproof a Room Stage2 Part 5Soundproof a Room Stage2 Part 5
In order to gain more height in the practice room, we had to lift the existing joists. In addition to this, the spacing of the existing ceiling joists was not convenient for the new ceiling design, so...
Read More >>
Soundproof a Room Stage3 Part 3Soundproof a Room Stage3 Part 3
Isolate fan mounting   Unfortunately, I discovered (after the ceiling of the practice room had been put up), that the foam used to provide vibration insulation was too dense. A significant level of...
Read More >>
logo footer   Designed by Marshallarts (c)1999-2010 - All Rights Reserved